Section 25: Direct Control of DMX Channels

Table of Contents

25.1: Manually specifying DMX Channel Values
25.2: Setting DMX Channels to External Art-Net Source
25.3: Reverting DMX Channels to HogNet Control
25.4: DMX Test

By default the DMX channel values output by the DP8000 are controlled by patched fixture data as programmed in the Hog show file. However, you may wish to override these values with manually entered DMX values or with Art-Net values streaming into the console from a remote third party Art-Net source such as another console. Both of these tasks can be accomplished in the DMX output window by following the instructions outlined in this chapter.

Figure 25.1. DMX Output Window

DMX Output Window